Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable AC Installation Across Broadview Park
AC installation in Broadview Park, FL typically runs $3,500-$7,500 for a complete system, depending on the home’s square footage, duct condition, and whether we’re working with an existing permitted addition or a Florida room that was never properly tied into the original air handler. We know this unincorporated community differently than most contractors do. The 1950s and 1960s CBS block homes here, the low-pitch attics that bake at 140°F, the standing-water condenser pads after afternoon storms: none of it surprises our crews anymore. Call (747) 966-3037 and we’ll walk through what your house actually needs, not what a brochure says it should get.
Key takeaways:
- Full central AC installation in Broadview Park runs $3,500-$7,500.
- We pull permits through the Broward County Building Division, not a city hall, because Broadview Park is unincorporated.
- Every quote includes a Manual J load calculation before we recommend a tonnage, because the old unit’s listed size is rarely what the house actually needs.
- Our 365-Day Done Right Promise backs every install. If it isn’t right, we make it right.
Why Meadowsweet Heating & Air Is Broadview Park’s Preferred AC Installation Company
Luis Serrano and our installation crews work in Broadview Park every week, from the tight lots along State Road 7 to the older CBS ranches off SW 36th Street and SW 30th Avenue. We understand that this is not a gated community with generous side yards and wide service clearances. It’s a dense, settled neighborhood of slab-on-grade homes built between 1955 and 1975, where condensers sit inches from fence lines and attic access hatches are narrower than code allows today. That shapes how we plan every job.
The Cedarwell Care Promise is the standard we hold to across the Cedarwell family of HVAC companies, founded in 2004. It means a written price before any work starts, background-checked uniformed technicians, and a 365-Day Done Right Promise that stands behind the job for a full year. Shoe covers and drop cloths go down before tools come out. A photo of the clean-up is sent before the crew leaves. Those are not upsells. They are the job.
Calls are answered by a live person 24 hours a day, 7 days a week, including nights and weekends. No voicemail queue.
Central Air Conditioning Installation in Broadview Park
Central Air Conditioning Installation in Broadview Park means more than bolting a new outdoor unit onto an old pad and reusing whatever ductwork happens to be in the attic. Given the age of this housing stock, a proper install here almost always involves duct assessment first. Many of these 1950s-1960s CBS homes still have original fiberglass duct board or crushed flex duct that cannot move enough air for a modern high-efficiency system. Installing a $7,500 variable-speed unit onto collapsed ductwork is money wasted. We check before we quote.
Manual J before tonnage
Because so many Broadview Park homes have Florida-room additions that were built without permits and tied into the original air handler, the tonnage listed on the old outdoor unit is almost never what the actual square footage demands. We run a Manual J on every replacement, no exceptions. The number on the data plate is not the number we build to.
Humidity is the real spec
Broadview Park sits in low-lying interior Broward County, a few miles from the Everglades edge, and indoor relative humidity runs above 60% for much of the year. A system sized only for cooling BTUs leaves a house feeling clammy at 74°F. We size for dehumidification capacity, not just temperature drop. For most homes here, that means a variable-speed air handler paired with a properly matched condenser.
Furnace Installation in Broadview Park
Furnace Installation in Broadview Park is a different conversation than what a homeowner in Jacksonville or Tampa faces. South Florida winters are short and mild, so furnaces here run fewer hours per year, but they sit in unconditioned spaces with punishing humidity, and that is what kills them. Heat strips and control boards corrode. Blower motors get dust-caked. A furnace that only cycles a dozen mornings a year still needs a clean install, proper condensate drainage, and static pressure within manufacturer spec, or it fails early and quietly.
Closet and utility-room installs
Many Broadview Park furnace closets are tight: the unit, the water heater, and the washer/dryer all share a few square feet. We protect the surrounding surfaces, redirect or box out combustion air properly, and leave enough clearance so the next repair does not require pulling the dryer out of the room. If the existing furnace is sharing a closet with a return plenum that is pulling lint from the dryer vent, we fix that during the install rather than leaving it.
What it costs here
A furnace replacement in Broadview Park runs roughly the same range as a central air install: $3,500-$7,500, depending on efficiency tier and whether we are addressing duct issues at the same time. Most homes here need a standard 80% AFUE gas furnace or an electric air handler with heat strips. We will show you the line items before you sign anything.
Trusted Brands We Service in Broadview Park
We install and service equipment from Goodman, Rheem, York, Daikin, and five other major brands. That matters in Broadview Park for two reasons. First, some brands have better humidity control profiles for low-sensible-load South Florida homes than others, and we will tell you which ones make sense for your house rather than selling whatever is on the truck. Second, we keep common parts for these brands stocked locally, so if a control board or a blower motor fails on a Broadview Park job, we are not waiting a week on a warehouse in Orlando. Faster turnaround, fewer hot nights.
Common AC Installation Problems We See in Broadview Park Homes
- Collapsed duct runs in 140°F attics. Original flex and duct board from the 1960s disintegrates under attic heat, crushing static pressure and starving the evaporator coil. Homeowners blame the compressor. The compressor is usually fine; the ductwork is the failure.
- Unpermitted Florida-room additions tied into an undersized air handler. Broadview Park’s unincorporated status means enforcement has been uneven over the decades. Additions get built, ducts get tapped in, and the original 2-ton system quietly fails to satisfy the now-1,400-square-foot house.
- Standing-water condenser pads after Everglades-edge storms. Flat ground, poor drainage, and intense afternoon thunderstorms mean outdoor units sit in water. Base panels corrode, electrical components rust, and the system fails from the bottom up.
- Rooftop and closet installations with zero service clearance. Dense lots and narrow side yards push condensers into tight spots. Some old installs left less than six inches between the unit and a fence, which is not enough for proper airflow or a repair tech’s hands.
We were called to a 1962 CBS ranch on SW 36th Street where the homeowner’s 2-ton Carrier was short-cycling every eight minutes and the house still felt clammy at 74°F. Our tech climbed into the low-pitch attic, found crushed flex duct and collapsing duct board running to a Florida room that had been added without a permit, and ran a Manual J that came back at 2.5 tons with a real dehumidification load. We installed a 2.5-ton Trane variable-speed heat pump with a proper return, upsized the duct run to the addition, and set the thermostat for 45% RH. The short-cycling stopped and the attic stopped cooking the supply air.
Pricing for AC Installation in Broadview Park, FL
Here are the line-item ranges we quote in Broadview Park. These numbers are fixed scope-of-work figures, not teaser prices.
| Service | Price Range |
|---|---|
| Central Air Conditioning Installation | $3,500-$7,500 |
| Furnace Installation | $3,500-$7,500 |
| AC Repair (reference) | $150-$650 |
| Tune-Up (reference) | $80-$200 |
What moves a Broadview Park install toward either end of the range: whether we are replacing ductwork, how difficult the attic access is, whether the electrical panel has room for a new breaker, and whether the existing pad needs to be rebuilt or elevated above standing water. Every quote includes the same standards: a written price before we start, shoe covers and drop cloths, and the 365-Day Done Right Promise. Call (747) 966-3037 for a free estimate, and we will put the exact number in writing before any work is scheduled.
We Also Serve Cities Near Broadview Park
While this page is focused on AC installation in Broadview Park, our crews regularly work in Jacksonville, Miami, Tampa, and Orlando as part of the broader Cedarwell service area. Scheduling and dispatch are coordinated from the brand’s Miami (South FL) office, and crews serve Broadview Park locally. You can read more about our AC Installation process or see the full Broadview Park service breakdown for additional detail.
Serving Broadview Park, FL - Our Local Coverage Area
We’re based in the Broadview Park area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About AC Installation in Broadview Park
Broadview Park is an unincorporated Broward County pocket, not a municipality, so every HVAC permit runs through the Broward County Building Division rather than a city hall. Contractors who work mainly in neighboring Fort Lauderdale or Dania Beach sometimes get tripped up on this. We file Broadview Park permits through the correct county path every week, so inspections are not delayed by paperwork errors. Call (747) 966-3037 and we will handle the permit filing as part of the install.
Yes, and it’s more important on a 1,100-square-foot Broadview Park CBS home than it is on a 3,000-square-foot new build. Many older homes here have unpermitted Florida rooms and enclosed porches tied into an air handler that was not sized for them. The old unit’s data plate might say 2 tons while the actual conditioned square footage demands 2.5. We run the Manual J before quoting any replacement, because matching the old tonnage without checking is how a brand-new system ends up short-cycling within a month. Call (747) 966-3037 and we will run the load calc for free as part of the estimate.
Yes, and in some of these older homes a mini split is the better answer. Ductless systems avoid the collapsed-duct problem entirely, and they deliver much better dehumidification control per room, which matters in an area flooded with Everglades-edge humidity. They also work well in Florida rooms and additions that never had proper duct runs to begin with. We install and service mini splits from several of the brands we carry, and the same written-price and 365-Day Done Right Promise standards apply. Call (747) 966-3037 and we will tell you honestly whether a mini split or a central system makes more sense for your floor plan.
Many Broadview Park lots are tight, with condensers sitting a few feet from the neighbor’s bedroom window, and Broward County does enforce daytime construction noise rules. We place condensers with enough clearance for airflow and future service, but also consider where the fan noise will travel. When a unit has to sit close to a property line or a window, we discuss pad placement, acoustic compressor blankets, and low-noise equipment options before the install happens, not after the neighbor complains. Call (747) 966-3037 and we will walk the lot with you before quoting.
Because the factory start-up is not the final word in a South Florida install. Broadview Park’s heat, humidity, and frequent lightning storms stress electrical components immediately. We verify the correct start and run capacitor ratings, confirm the refrigerant charge matches the manufacturer’s spec for our line-set length, and test the condensate drainage under real humidity load before we call the job done. If anything is off on day one, we fix it under the 365-Day Done Right Promise, not under a callback charge. Call (747) 966-3037 to schedule an install and we will run through the full start-up checklist with you.
Written by Luis Serrano, owner at Meadowsweet Heating & Air, serving Broadview Park as part of the Cedarwell family of HVAC companies.