Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Fast, Reliable Furnace Repair Across Grafton
Furnace repair in Grafton typically runs between $150 and $700, and most calls are diagnosed the same day. If your heat is out off Parsons Road or down near the village center, you’re probably not calling to price-shop three companies. You’re cold. You need a real person to answer and a tech who knows that a house on Crook Street built in 1947 doesn’t fail the same way a 1990s split-level off State Route 57 does. That’s the work we do. Call (747) 966-3037 and a live person answers, 24 hours a day.
Why Meadowsweet Heating & Air Is Grafton’s Preferred Furnace Repair Company
Grafton is a small village. Word travels. If a crew leaves muddy boot prints across a kitchen floor on Chestnut Street, half the township hears about it by Friday. That’s why we run every Grafton job through the Cedarwell Care Promise, and it’s why our techs wear shoe covers, lay drop cloths, and send you a photo of the clean-up before they pull out of the driveway. Not as an add-on. That’s just how the job gets done.
Luis Serrano leads our team, and he’s built the Grafton service approach around one question: how will this house feel when we leave? The furnace is fixed, yes. But the floors are also clean, the pet area wasn’t disturbed, and the kids can go right back to playing in the living room. That matters to families in Grafton, and it matters to us.
We know the housing here. The 1920s bungalows near the railroad tracks, the 1950s ranches out toward LaGrange, the older farmhouses on township roads where the furnace is the third one that house has ever had. We carry parts for nine brands including Goodman, Rheem, York, and Daikin, and we keep our Grafton area trucks stocked so a failed igniter doesn’t send us back to a supply house across the county line.
Boiler Repair in Grafton
Boiler repair is a regular part of our winter workload in Grafton’s oldest homes, where hydronic boiler-and-radiator systems still heat the same rooms they did in the 1940s. A boiler repair in Grafton typically lands between $150 and $700 depending on whether the call is a failed circulator pump, a faulty aquastat, or a leaking pressure relief valve. The oldest boilers around the village proper and the township roads south of Route 82 often need attention not to the burner alone, but to the whole loop: air in the lines, sludge in the cast-iron sections, a pressure problem nobody noticed until the radiators went cold.
What a Grafton homeowner notices first is usually a cold radiator or two downstairs while the upstairs ones still get warm, or a boiler that fires, shuts off, fires again, and rattles the pipes. That short-cycling isn’t noise you should ignore. It’s the boiler telling you the water isn’t moving the way the system was designed for.
When a boiler fails differently than a forced-air furnace
A boiler holds its heat longer and fails slower than a gas furnace, which means the symptoms are quieter. A drop in system pressure, a hissing radiator valve, banging when the burner kicks on. Grafton homes with original cast-iron radiators often have 70-year-old zone valves that stick and need replacement, not a boiler replacement at all.
How we approach boiler repairs without causing more damage
Draining and refilling an old boiler system in a Grafton home is an invitation for air locks and new leaks if it isn’t done patiently. We test operating pressure, check the expansion tank, and bleed the radiators methodically. The fix on one visit, not a sequence of callbacks. Every boiler repair gets a written price before the first tool comes off the truck.
Gas Furnace Repair in Grafton
Gas furnace repair in Grafton covers two distinct realities: natural gas furnaces in the village proper, and propane or fuel-oil units on the outskirts and township roads where the natural gas main never reached. A gas furnace repair here runs $150 to $700, and the most common winter calls are failed hot-surface igniters, dirty flame sensors, and cracked heat exchangers. On propane systems, those failures show up differently than on natural gas. The burner orifice sizing is wrong if a previous tech swapped in a generic part. The pressure at the manifold is off. The combustion analysis tells you the story if you take the time to read it.
You don’t need a furnace specialist who has only ever worked on new construction in tract housing. You need a tech who knows that a 1960s ranch off a rural road near the Grafton Correctional Institution might be running on a 100-gallon propane tank behind the shed, and that the furnace’s original burner wasn’t converted correctly twenty years ago when somebody did a shortcut job. We see it regularly.
Furnace ignitor and gas valve replacement
An ignitor that won’t glow, or glows but won’t light the burners, is one of the most common furnace repair calls in Grafton from mid-December through March. On propane furnaces, the igniter runs hotter and fails on a different cycle than natural gas. The gas valve itself can stick, hum without opening, or fail to hold the correct manifold pressure. We test before we replace, and the written price is on the table before you’d ever approve a part swap.
When the heat exchanger is the real problem
A cracked heat exchanger is a safety issue, not a performance issue. On older Grafton furnaces with undersized ductwork, the exchanger runs hotter than it should because airflow is starved, and the metal stress eventually cracks. We don’t just patch and walk. We measure static pressure, show you the reading, and explain what needs to happen so a new exchanger doesn’t crack the same way next winter. Heat exchanger work can approach the top of the $150-$700 furnace repair range, and sometimes the honest answer is that replacement is the better path. We’ll tell you that plainly and price it in writing either way.
Trusted Brands We Service in Grafton
We service and repair furnaces from Goodman, Rheem, York, and Daikin, among others. Nine brands total. For Grafton customers, that matters because we’re not tied to one manufacturer’s parts channel. We can source the right propane-rated igniter, the correct conversion kit, or a replacement gas valve without a week of waiting. The village’s mix of aging equipment means no two trucks roll out with the same parts list, and ours are stocked for the equipment that actually lives in these houses, not what’s on sale at a distributor.
Common Furnace Repair Problems We See in Grafton Homes
- Propane and fuel-oil systems off the natural gas main. Burners, orifices, and igniters fail differently on propane than natural gas, and a generic replacement part won’t hold calibration. Homes along the township roads and the rural stretch past the correctional institution see this more than almost any other failure mode.
- Undersized original ductwork from the 1920s through 1960s. Starved airflow drives up static pressure, which cooks heat exchangers and shortens blower motor life. It also makes the house feel uneven no matter what the thermostat says.
- Single-zone systems fighting unbalanced floor plans. One furnace in the basement trying to heat a whole older Grafton house means far bedrooms stay cold while the living room blasts warm, and the furnace short-cycles because the thermostat is in the warmest spot in the house.
- Old electrical panels and controls that complicate modern repairs. Many of Grafton’s older homes still have original panels that need attention before a modern blower motor or control board can operate safely. We’ll flag it when it affects the furnace repair, and we won’t work around a hazard.
Pricing for Furnace Repair in Grafton, OH
A typical furnace repair in Grafton falls within $150 to $700. The most common calls, an igniter replacement or a failed flame sensor, sit at the lower end of that range. Boiler repairs and gas valve work land mid-range. A cracked heat exchanger or a blower motor replacement can push toward $700. The price depends on the furnace’s age, whether it’s propane or natural gas, and how accessible the equipment is.
Here’s how the pricing breaks down in Grafton’s market:
| Repair Type | Typical Grafton Price Range |
|---|---|
| Gas Furnace Repair | $150-$700 |
| Boiler Repair | $150-$700 |
Every job includes a written price before any work starts. You’ll see the cost, approve it, and then we start. Estimates are free. Call (747) 966-3037 and we’ll get a tech headed toward Grafton.
We Also Serve Cities Near Grafton
Beyond Grafton, our techs regularly run calls to LaGrange, Elyria, North Ridgeville, and Olmsted Falls. The drive times are short, and the housing stock is familiar. If you’re in any of those communities and your furnace quit on a cold night, the same Furnace Repair team is on call. For more about our work in this area, see Furnace Repair in Grafton.
Serving Grafton, OH - Our Local Coverage Area
We’re based in the Grafton area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Grafton
Yes. Propane-rated furnace components and conversion kits are standard stock on our Grafton area trucks, and our techs are trained on the different failure patterns of propane vs. natural gas systems. A generic replacement part from a natural-gas job won’t hold on propane, so we size and test everything against the manufacturer’s propane specifications. Call (747) 966-3037 and tell the live person who answers that your Grafton home is on propane, so we send the right tech with the right parts the first time.
Because the furnace wasn’t the only problem, and on Grafton’s 1920s through 1960s homes it rarely is. The original ductwork was sized for a low-efficiency furnace that moved air differently, so even a perfectly repaired furnace can’t push enough air to far rooms. We measure static pressure after repairs on older Grafton homes and tell you exactly what the ductwork is contributing. Sometimes it’s a damper adjustment. Sometimes it’s a duct job. We’ll give you the numbers and the options, not a guess.
You can, but in Grafton’s older homes a like-for-like swap often repeats the same problems: starved airflow, short cycling, and rooms that never warm up. The better path is a load calculation and a static pressure reading before you choose equipment, which we do as part of evaluating the job. It costs time, not extra money, and it means you don’t pay twice for the wrong furnace. Call (747) 966-3037 and we’ll walk you through what the numbers show for your house.
Yes. We repair and service boiler-and-radiator systems throughout Grafton, including the oldest homes near the village center and the farmhouses on the township roads. The work is different from forced-air repair: pressure, expansion, zone valves, and air bleeding all come before burner diagnostics on a hydronic system. Our techs carry the right fittings and know how to work on cast-iron radiators without cracking a floor or a pipe. Estimates are free at (747) 966-3037.
Most Grafton furnace repairs are diagnosed and completed in 90 minutes to 3 hours once the tech is on site. An igniter or flame sensor replacement is quick. A gas valve or blower motor takes longer. A heat exchanger replacement can run half a day. You’ll get a written price and a realistic time estimate before the work begins, and our techs respect your family’s time, including quiet hours around napping kids and pets. Call (747) 966-3037 any time; dispatch and scheduling for Grafton are coordinated from our metro office, and crews serve the village locally.
Call Meadowsweet Heating & Air for Furnace Repair in Grafton
If your furnace is down in Grafton, call (747) 966-3037. A live person answers at 3 a.m. the same way they do at noon. We’ll dispatch a background-checked, uniformed tech who knows this village’s older homes, its propane systems, and its undersized ductwork. You’ll get a written price before any work starts, shoe covers and drop cloths on every visit, a photo of the clean-up before we leave, and a 365-Day Done Right Promise behind every repair. That’s the Cedarwell Care Promise, and it’s how every Grafton job gets done.
Written by Luis Serrano, Owner at Meadowsweet Heating & Air, serving Grafton through the Cedarwell family of HVAC companies since 2004.







Before
After
Before
After
Before
After