Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Redan
Furnace repair in Redan typically runs $150-$700, with most fixes completed in a single visit. If your heat won’t start on a cold Redan morning, call (747) 966-3037 and you’ll reach a live person who can schedule a technician. The crew at Meadowsweet Heating & Air knows the brick ranches and split-levels waiting for heat in neighborhoods off Redan Road and Panola Road, and we show up fast when the cold settles into DeKalb County.
Why Meadowsweet Heating & Air Is Redan’s Preferred Furnace Repair Company
Families across Redan call us because we write down the price before any work begins. That’s the Cedarwell Care Promise, and it’s non-negotiable on every visit. Luis Serrano, who leads our team, set a standard from day one: background-checked technicians in uniform, shoe covers on inside your home, and a photo of the clean-up before the crew leaves. It’s not an upsell. It’s how we work. The 365-Day Done Right Promise means if a repair isn’t done right, we make it right with no runarounds.
Our furnace repair techs work on systems throughout Redan’s 30074 and 30088 zip codes, from the streets around Miller Grove Road to the neighborhoods near Redan High School. We know these homes. Slab foundations, brick exteriors, attic-run flex duct pushing through 130-degree summers. That local knowledge changes how we diagnose a furnace that won’t ignite or a blower that keeps tripping.
Boiler Repair in Redan
Boiler repair in Redan covers a smaller slice of homes than furnace work, but those boilers tend to be older hydronic systems in the brick ranch stock built between the 1970s and early 1990s. When a boiler loses pressure, leaks around a circulator pump, or stops heating zones evenly, the issue is usually a failing expansion tank, a stuck zone valve, or air trapped in the lines. Parts and labor for these jobs run within the $150-$700 furnace repair range depending on what’s failed.
Hydronic Loop Repairs
A boiler that heats the first floor but leaves the back rooms cold often has a stuck zone valve or a circulator that’s lost its prime. We diagnose it with a pressure check and zone-by-zone temperature reading before opening anything up. The written price comes first, every time.
Pressure and Expansion Tank Service
Redan’s temperature swings put real stress on older expansion tanks. When a tank waterlogs, the boiler pressure climbs and the relief valve drips. We replace the tank, refill the loop, and bleed the air. That’s usually a same-day fix.
Gas Furnace Repair in Redan
Gas furnace repair in Redan most often comes down to three culprits: a failed ignitor, a cracked heat exchanger, or a control board fried by a storm-season power surge. When the gas valve opens but the burners won’t light, it’s frequently the ignitor, a $150-$400 repair including the part. We carry ignitors, flame sensors, pressure switches, and control boards for the brands most common in Redan so we’re not making you wait on a parts truck from across town.
Ignitor and Flame Sensor Replacement
The ignitor on a gas furnace is a wear item. If you’re hearing the furnace click but no flame catches, that’s the likely point of failure. We test it, show you the old part, and quote the replacement before we turn a wrench.
Heat Exchanger Inspection
This one matters for safety. A cracked heat exchanger can put carbon monoxide into living space, and it should be checked by a trained professional with a combustion analyzer, never handled DIY. We open furnaces across Redan every winter and find cracks, especially on units that ran hot because collapsed attic ductwork choked airflow for years. The price to replace a heat exchanger or condemn the unit falls inside the standard repair range, and we’ll always show you what we found with a photo.
Trusted Brands We Service in Redan
Our techs repair equipment from the brands Redan families actually have: Trane, Lennox, Goodman, and Rheem among them. Because we service a lot of these systems here, we stock common parts in our local vans, which means fewer return trips and a faster fix when the temperature drops. Whether your furnace is a Rheem from the early 2000s or a newer Trane, the Furnace Repair team has the tools and the manufacturer-specific training to diagnose it correctly the first time.
Common Furnace Repair Problems We See in Redan Homes
- Collapsed flex duct driving blower failure. The original 1970s-1990s flex runs in Redan attics sag under blown insulation. That raises static pressure until the blower motor overheats and the furnace short-cycles, especially after July’s 130-degree attic heat bakes the ductwork all summer.
- Post-storm control board failures. A power surge from a summer thunderstorm or winter ice event takes out the capacitor-fed blower motor or the control board on older Redan furnaces. The fix is a proper part replacement after a board-level diagnostic, not a reset that hides the damage.
- Flooded condensate pans and blocked drains. Metro Atlanta’s humidity keeps Redan drain lines saturated year-round. A partially blocked drain that held through spring becomes a pan overflow or a rusted-out heat exchanger by fall.
- Short-cycling with uneven heat. When a furnace fires for five minutes, shuts off, and the back bedrooms still feel cold, the system is usually fighting duct static pressure, not a bad furnace. We measure that before we condemn any equipment.
Pricing for Furnace Repair in Redan, GA
Here’s what furnace repair actually costs in Redan right now.
| Service | Redan Price Range |
|---|---|
| Furnace Repair | $150-$700 |
| AC Repair | $150-$650 |
| Tune-Up | $80-$200 |
| AC Installation | $3,500-$7,500 |
A simple ignitor or flame sensor replacement lands near the bottom of that range. A blower motor replacement, a control board, or a repair that requires opening and re-sealing buried ductwork lands higher. Every job starts with a free estimate and a written price before any work begins, so you’ll know the number before you say yes. Call (747) 966-3037 for an exact quote.
We Also Serve Cities Near Redan
Beyond Redan, our crews run calls to Stone Mountain, Clarkston, Conyers, and Snellville. If your furnace quits in any of those communities, the same written-price standard and 365-Day Done Right Promise apply. A live person answers at (747) 966-3037 day or night.
Serving Redan, GA - Our Local Coverage Area
We’re based in the Redan area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Redan
No. Never power on a furnace or AC condenser that sat in floodwater. Water inside the electrical windings can short the compressor or blower motor the instant power returns. Our technicians in Redan dry the unit, run a megger test on the windings, and inspect the control board before restoring power. Call (747) 966-3037 and we’ll walk through the safe restart sequence with you.
In most Redan homes, the blower motor isn’t failing on its own. Buried flex duct from the original build collapses under attic insulation and drives static pressure up until the motor windings overheat season after season. We replace the motor only after we measure duct pressure, because putting a new motor on a choked duct stack means you’ll be replacing it again in two winters.
Two components fail first: the control board and the capacitor-fed blower motor. Older Redan furnaces without surge protection are the most exposed. A fused control board won’t respond to the thermostat, and a damaged motor may hum without spinning. We diagnose both components, quote the repair, and can add surge protection so the next storm doesn’t do the same damage.
For a repair, no. SEER2 is an efficiency rating that matters when you’re replacing an air conditioner or heat pump, not when we’re swapping an ignitor, pressure switch, or control board on your furnace. We’ll give you the straight answer on repair versus replacement when the time comes, and show you the numbers either way.
In Redan’s slab-foundation brick ranches, it’s almost always the ducts. The furnace is fine. The real problem is collapsed flex runs in the attic driving static pressure high enough to trip the high-limit switch, so the furnace shuts down before heat reaches the far rooms. A technician who only looks at the furnace will miss it. We always check the duct system in Redan homes because we know that’s where the problem lives.
Call Meadowsweet for Furnace Repair in Redan
When the furnace quits on the coldest night of the year, you want a crew that answers the phone and shows up with a written price. You get that with Meadowsweet Heating & Air. Shoe covers go on at the door. Drop cloths protect the floors where your kids and pets play. The cleanup photo gets sent before we leave. That’s the Cedarwell Care Promise from Luis Serrano’s team. Call (747) 966-3037 now for a free, written estimate on furnace repair in Redan, GA.
Written by Luis Serrano, Owner at Meadowsweet Heating & Air, serving Redan through the Cedarwell family of HVAC companies.