Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable AC Installation Across Felida
AC installation in Felida typically runs $3,500 to $7,500 for a complete central air or heat pump system, depending on home size, ductwork condition, and whether you’re also replacing the furnace. Most Felida jobs take one to two days once permits clear Clark County. We serve every street in Felida, from Lakeshore to the ridge lots above NW 119th, and we answer the phone live whenever you call (747) 966-3037.
Felida’s housing stock has a particular rhythm: the plateau was built out almost entirely between the mid-1990s and mid-2000s, which means hundreds of original heat pumps up here are hitting the 20 to 25 year mark at roughly the same time. We know those systems, we know how they were sized, and we know what it takes to replace them correctly on the first pass. That local knowledge matters when your condenser has been eating fir pollen on a ridge lot for two decades.
Why Meadowsweet Heating & Air Is Felida’s Preferred AC Installation Company
Luis Serrano leads the Meadowsweet team, and he built the company’s approach around a simple question: what does the house look like when we leave? Every crew member follows the C.A.R.E. values code, which means Clean up like it’s their own home, Ask before moving anything, Respect the family’s time and quiet hours, and Explain the price before the work. On a Felida install, that translates to shoe covers over wool carpet in a two-story foyer, drop cloths across the hardwood hallway to the mechanical room, and a photo of the clean-up sent before we pull out of the driveway.
Our AC Installation team carries nine major equipment brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. That matters for Felida because so many homes here were built with a specific tonnage and cabinet footprint. We can match your existing duct transitions without a week of waiting for parts. Every job gets a written price before any work starts, and the 365-Day Done Right Promise stands behind it. If it’s not done right, we make it right. No runarounds, no fine print.
Response time to Felida is usually same-day for emergency diagnostics and next-day for install scheduling. We dispatch from our metro office, but the crews work locally on the plateau and know the roads, the permit counter, and the inspectors.
Central Air Conditioning Installation in Felida
Central Air Conditioning Installation in Felida means replacing or adding a full split system: an outdoor condenser, an indoor evaporator coil, a matched air handler or furnace, and the line set connecting them. For most Felida homes in the 2,500 to 4,500 square foot range, a complete central air installation runs $3,500 to $7,500. That figure includes the equipment, the installation labor, the refrigerant charge, and the startup testing. It does not include major ductwork replacement, which we only recommend after we’ve actually inspected your ducts.
Sized for the Plateau, Not a Generic Formula
Felida sits higher than the Columbia River lowlands, and the ridge gets more wind than people realize. That exposure erodes condenser coil fins over time and forces equipment to work against a constant breeze that strips heat transfer surface. A correctly sized system for an exposed Felida lot accounts for that wind load, the lack of a windbreak, and the fact that your home faces the open sky rather than a neighbor’s wall. Our load calculations use current Manual J software, not the pre-2000 standard that sized your original system.
Permits Run Through Clark County
Because Felida is unincorporated, your AC installation permit doesn’t go through the City of Vancouver. It’s filed with Clark County Community Development, and their plan reviewers want to see the load calculation attached to the application. We handle that paperwork for you, and we’ve filed enough Felida permits to know exactly what the county looks for before they sign off on the mechanical final.
Furnace Installation in Felida
Furnace Installation in Felida is usually paired with AC installation because the two systems share the same air handler and ductwork. If your 1990s furnace is still original and you’re replacing the AC, replacing both at once avoids a second permit, a second tear-up of the mechanical room, and a second round of labor charges down the road. A furnace add-on with a new AC installation in Felida runs $3,500 to $7,500 for the combined job, depending on furnace efficiency and whether you’re converting from electric air handler to a propane furnace.
Propane Heat on Rural Parcels
A meaningful number of Felida properties sit on larger rural parcels where natural gas never came up the hill. If you heat with electric or propane now, we can pair your new central AC with a high-efficiency propane furnace rather than an electric air handler. That gives you two fuel sources, which matters when a winter storm knocks out power and you still want heat. We’ll spec the furnace to your existing propane tank and line pressure so there’s no surprise regulator work.
Outbuilding and Workshop Conditioning
Some Felida homes have detached shops, barns, or hobby spaces that were never conditioned when the main house was built. Rather than tapping the house system, which almost always undersizes the run and freezes out the kids’ rooms, we’ll quote a dedicated mini split for the outbuilding. A single-zone mini split on a detached workshop keeps the space at a working temperature without stealing conditioned air from two stories of living space.
Trusted Brands We Service in Felida
We install and service Trane, Lennox, Goodman, and Rheem equipment, among others, and we keep common Felida-specific parts on the truck. That matters when an older Goodman condenser finally quits during a July heat wave and you don’t want to wait ten days for a compressor. While we work across nine major brands, we tend to spec Trane and Lennox heat pumps for Felida’s damp winters and increasingly hot summers because their coil corrosion protection holds up better in our climate than lighter-duty builder-grade units. We’ll never push a brand your ductwork can’t support.
For a closer look at how we work across the neighborhood, see our AC Installation in Felida overview page, where we explain the full process from load calculation to final inspection.
Common AC Installation Problems We See in Felida Homes
- Pre-2000 Manual J sizing failures. Original 1990s heat pumps in Felida were sized to a milder design temperature than the heat we actually get now. A 3-ton system that ran fine in 1998 runs continuously in a Clark County heat wave and still never reaches the thermostat setpoint. The fix is a current load calculation, not a bigger unit by guesswork.
- Plateau wind exposure and fir pollen packing condenser fins. Ridge lots without a windbreak get steady wind that drives fir pollen deep into the outdoor coil. The pollen mixes with moisture, cakes onto the fins, and raises head pressure until the compressor trips or fails. We see this constantly on Felida’s hillside properties, especially on lots facing west.
- Undersized runs to detached outbuildings. When a previous owner tapped a house system to cool a shop or a bonus room over the garage, the duct run is almost always too small. The far space never cools, the rest of the house overcools, and the homeowner ends up paying for a second system anyway. We measure the actual duct dimensions and tell you what the run can and cannot do before we quote a separate mini split.
- Two-story stratification with a single return. Many late-1990s Felida two-story homes were built with one central return in the upstairs hall. In summer, the upstairs bedrooms hold heat at 80 degrees while the main floor sits at 72. Adding a return or adjusting the zoning is sometimes the actual fix, and we’ll say so instead of just selling a larger condenser.
Pricing for AC Installation in Felida, WA
Here’s what we quote for Felida work:
| Service | Price Range |
|---|---|
| Central Air Conditioning Installation | $3,500 - $7,500 |
| Furnace Installation (add-on with AC) | $3,500 - $7,500 |
What moves the number inside that range for a Felida house: whether we’re reusing existing ductwork or modifying it, whether the condenser needs a pad raised above grade on a windy slope, whether you want a single-stage or variable-speed system, and whether you’re adding a propane furnace on a parcel without natural gas. We give you a written price before any work starts, and estimates are free. Call (747) 966-3037 and we’ll come out, walk your mechanical room, and put the number on paper.
Key takeaways: Felida AC installation runs $3,500 to $7,500 for a full system. Permits go through Clark County Community Development, not the City of Vancouver. Most 1990s Felida heat pumps were undersized by today’s heat standards. We provide a written price before work begins, and the 365-Day Done Right Promise backs every job.
We Also Serve Cities Near Felida
While this page focuses on Felida, our crews also cover Seattle, Spokane, Tacoma, and Vancouver. If you have a property in one of those areas or a family member who needs a second opinion on an AC quote, call the same number and we’ll route the right crew to the right side of the metro. The standards are the same everywhere: written price, shoe covers, clean-up photo, and a one-year guarantee on the work.
Serving Felida, WA - Our Local Coverage Area
We’re based in the Felida area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About AC Installation in Felida
Yes, any new AC installation or replacement in unincorporated Felida requires a mechanical permit from Clark County Community Development. The permit goes through the county, not the City of Vancouver. Our team files the application, attaches the load calculation, schedules the inspection, and walks the final with the inspector. Call (747) 966-3037 and we’ll handle the whole file from application to sign-off.
In most cases, yes. Felida’s original 1990s heat pumps are now 20 to 25 years old, and most were sized to pre-2000 Manual J standards that underestimated today’s summer heat. Even if yours still runs, the efficiency loss alone can cost you hundreds in extra power each summer. Replacing on a planned schedule is cheaper than an emergency swap during the next heat dome, and it gives you time to choose equipment rather than taking whatever is on the truck. Call (747) 966-3037 for a written quote before it fails at the worst possible time.
We run a current Manual J load calculation that includes your exact square footage, window orientation, ceiling height, insulation depth, and the wind exposure of your specific ridgeline. Felida’s plateau wind strips heat transfer surface from the outdoor coil over time, so we account for that when choosing the condenser and its mounting location. A unit tucked behind a windbreak on the east side of the house will live longer than one mounted open on the west ridge. We’ll tell you which location actually makes sense for your lot before we quote the install.
SEER2 is the updated efficiency standard that replaced SEER in 2023, and it measures how much cooling you get per watt of power under more realistic testing conditions than the old test used. Washington state energy code now has minimum SEER2 requirements, and Felida homes with original 1990s equipment are far below them. A higher SEER2 system costs more upfront but uses less power during long summer runtimes. For a two-story Felida home in the 3,000 square foot range, the efficiency difference between a 14 SEER2 and an 18 SEER2 heat pump can be noticeable on August power bills. Call (747) 966-3037 and we’ll show you the payback math on paper for your actual home, not a generic brochure.
For a standard central air or heat pump replacement with existing ductwork, expect one full day for the mechanical work plus a second short visit for the start-up test and final documentation. If we’re adding a propane furnace, reconfiguring duct transitions, or installing a mini split in a detached shop, plan for two days. Permitting adds a few days on the front end depending on Clark County’s review queue. We’ll give you a set install date when we provide the written quote, and we hold to it.
Call Meadowsweet for AC Installation in Felida
If your Felida home is still running its original 1990s heat pump, or if your house hasn’t held temperature through the last few summers, we’ll take a real look at it. No pressure, no guesswork, just a written price and a set date. Luis Serrano and the Meadowsweet crew understand how Felida homes were built, how the plateau wind ages outdoor units, and what Clark County expects on every permit file. Call (747) 966-3037 for a free estimate, and we’ll treat your floors, your kids, and your time the way we’d want a crew to treat our own place.
Written by Luis Serrano, Owner at Meadowsweet Heating & Air, serving Felida with AC installation you can trust.