Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable AC Installation Across Kennedale
AC installation in Kennedale typically runs $3,500 to $7,500 for a complete system, and in most cases our crew can have your new unit running within one to two days of your approval. We work throughout Kennedale’s established ranch-home neighborhoods, from the streets off Kennedale Parkway to the subdivisions east of 287, so we know exactly what these 1970s through 1990s slab-foundation homes need. When your old R-22 system finally gives out, you don’t need a guesser. You need someone who has measured static pressure in a hundred Kennedale attics. Call (747) 966-3037 and our AC Installation team will give you a written price before any work starts.
Why Meadowsweet Heating & Air Is Kennedale’s Preferred AC Installation Company
We’re part of the Cedarwell family of HVAC companies, founded in 2004, and every job we do in Kennedale carries the Cedarwell Care Promise: a written price before work begins, background-checked uniformed technicians who follow the C.A.R.E. values code, and a 365-Day Done Right Promise that means if something isn’t right, we make it right. No runarounds. No fine print. Luis Serrano leads our team, and he holds our people to a simple standard: leave the house the way you’d want your own left. That means shoe covers on every visit, drop cloths down before any equipment moves through the hallway, and a photo of the clean-up before the crew pulls out of the driveway.
What Kennedale homeowners tell us matters most is that we answer the phone. A live person picks up 24 hours a day, 7 days a week, including nights, weekends, and holidays. No voicemail queue. When it’s 102°F in July and your condenser just quit by the railroad tracks off Mansfield Highway, you need a real voice, not a recording. Our dispatchers coordinate from the Dallas-Fort Worth office, and our crews serve Kennedale locally, so response times are measured in hours, not days.
Central Air Conditioning Installation in Kennedale
Central Air Conditioning Installation in Kennedale means replacing an aging split system with a new, properly sized condenser and evaporator coil, and that job almost always involves a decision about the ductwork hiding in your attic. In Kennedale specifically, homes built between the 1970s and 1990s often have original fiberglass duct board and first-generation flex duct that is degrading at the same time as the R-22 equipment it’s attached to. A full central air installation in Kennedale runs $3,500 to $7,500, and we always check static pressure and duct condition before we quote a tonnage. That check is what prevents you from paying for a 4-ton system when the real problem is a crushed 3-ton duct run.
Replacing an R-22 System
If your Kennedale home still runs on R-22, you’re already living on borrowed time. R-22 is no longer produced or imported in the United States, and what little remains in reclaimed supply has driven repair costs to $150 to $650 with diminishing returns. The practical answer is a SEER2-rated replacement that uses R-410A or a newer refrigerant, sized to your actual duct capacity and your actual heat load, not to whatever the builder put in forty years ago.
Attic and Closet Air Handler Options
Many Kennedale ranch homes have air handlers in hallway closets or attic spaces with tight clearances. We plan for that. A horizontal attic unit or a compact closet unit has to fit through your existing access, and we’ll tell you before the work starts whether the new coil will clear your attic ladder. No surprises on install day.
Furnace Installation in Kennedale
Furnace Installation in Kennedale usually pairs with the AC replacement because the blower, the cabinet, and the duct connections all wear together. A gas furnace in a 1980s ranch home has spent years cycling through black-soil humidity and attic heat, and the heat exchanger doesn’t care how well the AC works. A new furnace installation in Kennedale runs $3,500 to $7,500, depending on efficiency and whether you’re replacing a standard 80% unit or upgrading to a 90%+ high-efficiency model with a sealed combustion vent.
Gas Furnace Replacement
Most Kennedale homes heat with natural gas, and the February 2021 freeze exposed how many older furnaces had no freeze protection on condensate drains or refrigerant line sets. A new gas furnace install includes proper drain routing, freeze protection where it’s needed, and a static pressure check on the existing ductwork before we light anything. If your duct run is collapsed from Blackland Prairie clay movement, that gets fixed before the new furnace goes in, not after.
Heat Pump and Dual-Fuel Options
For Kennedale homeowners who want to reduce gas usage or add a heat pump, we size and install heat pump systems that match your existing duct configuration. A dual-fuel setup can run the heat pump in mild weather and the furnace when it drops below freezing, which matters after what Uri showed us all.
Trusted Brands We Service in Kennedale
We service and install equipment from nine major brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. In Kennedale, we commonly recommend Goodman and Rheem for budget-conscious full replacements, and we install Carrier and Trane systems where homeowners want premium components and longer manufacturer warranties. Because our crews stock common parts for these brands locally, we can often turn around a failed part the same day instead of waiting on a distributor shipment from Fort Worth. You pick the brand, and we’ll give you the written price before the work. No obligation, no pressure.
Common AC Installation Problems We See in Kennedale Homes
- Slab-edge flex duct crushed by Blackland Prairie clay. The expansive clay under Kennedale’s slab foundations shifts enough seasonally to crush or separate flex duct runs along the slab edge. That creates chronically warm rooms that get misdiagnosed as undersized equipment, which can lead to an unnecessary tonnage upsell if nobody measures static pressure first.
- Fiberglass duct board liner breakdown. The attic heat in Kennedale regularly exceeds 140°F in July and August, and that sustained heat accelerates liner breakdown in ducts installed during the 1970s through 1990s. When the liner delaminates, it sends fiberglass particles into the air stream and collapses airflow, and we find this on a large share of installs where the ducts were never touched.
- R-22 equipment changeover complications. Older Kennedale homes with original R-22 condensers can’t just swap in a new compressor. The refrigerant changeover requires either a full system replacement or a conversion that many manufacturers no longer support, and combining that with simultaneous duct degradation is the double-replacement cycle we manage constantly here.
- Manufactured and mobile home sizing issues. Kennedale has a notable share of manufactured and mobile homes, and those need different equipment sizing, pad setups, and duct configurations than site-built ranch homes. A standard 3-ton condenser and slab-side coil plan won’t fit, and in some cases a mini split is the only practical option when ductwork can’t be run.
Pricing for AC Installation in Kennedale, TX
Here’s what you can expect to pay for installation work in Kennedale, with actual numbers you can plan around.
| Service | Typical Kennedale Price Range |
|---|---|
| AC Installation | $3,500 - $7,500 |
| Furnace Installation | $3,500 - $7,500 |
| AC Repair | $150 - $650 |
| Furnace Repair | $150 - $700 |
| Tune-Up | $80 - $200 |
What moves the price on a full AC install in Kennedale is the condition of the duct run, the tonnage your home actually needs (usually 2.5 to 4 tons for a ranch of 1,400 to 2,800 square feet), and the efficiency level you choose. A SEER2 14.5 system costs less than a SEER2 17 system, and a high-efficiency furnace with a sealed combustion vent adds material and labor. Call (747) 966-3037 for a free estimate. Luis Serrano or one of our comfort advisors will walk you through the written quote and answer any questions before you commit to anything.
We Also Serve Cities Near Kennedale
Our AC Installation in Kennedale work regularly takes our crews into the surrounding Tarrant County communities, including Arlington, Mansfield, Burleson, and Fort Worth. If you’re just across the city line, call us. We’ll let you know the next available slot and give you the same written-price-before-work guarantee, wherever you are in the area.
Serving Kennedale, TX - Our Local Coverage Area
We’re based in the Kennedale area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About AC Installation in Kennedale
That room is almost always the victim of a crushed or separated flex duct run along the slab edge, not an undersized system. The Blackland Prairie clay under Kennedale’s slab foundations expands and contracts enough to pinch or disconnect duct runs, and if we don’t measure static pressure and inspect the duct run, any new system will keep sending most of its air to the wrong rooms. We check the duct first, before we recommend any equipment change. Call (747) 966-3037 and we’ll send someone to measure what’s actually happening in your attic.
Yes. In some Kennedale homes, particularly manufactured and mobile homes or ranch additions where a ducted central system isn’t practical, a mini split can be the right answer. Ductless systems allow room-by-room temperature control, and they avoid the crushed-duct problem entirely because there is no flex duct in a slab-edge chase. If your ductwork is beyond repair, we’ll tell you that straight.
Yes, Kennedale requires a mechanical permit for AC and furnace installations, and our team pulls the permit and schedules the inspection as part of the job. We don’t ask you to handle the paperwork. We know the city’s inspection process and we’re used to coordinating with the city on the specific code requirements for slab homes and manufactured housing within Kennedale city limits.
Your practical options are a full system replacement with a SEER2-rated unit that uses current refrigerants, or continued patch repairs at $150 to $650 per call until a major component fails. For most 1990s homes in Kennedale, the wise move is a full replacement now, because the R-22 supply is shrinking and the older coil and condenser are already past typical service life. We’ll give you a written replacement price before you decide anything.
Expect $3,500 to $7,500 for a complete AC installation in Kennedale, depending on tonnage, efficiency level, and the condition of your existing duct run. A furnace installation in Kennedale lands in the same $3,500 to $7,500 range. We always provide a written price before any work starts, and our estimates are free. Call (747) 966-3037 to get an exact number for your home.
On a 1978 ranch in the established Kennedale core, we replaced a failed R-22 condenser with a 3-ton Carrier system and found the original fiberglass duct board and flex run crushed where Blackland Prairie clay had shifted along the slab edge. We rebuilt the duct run, verified a 0.5-in. w.c. static pressure, and added freeze protection on the refrigerant line set and condensate drain so the next Uri-style event doesn’t repeat the February 2021 emergency calls. That’s the difference between installing an AC box and installing an AC system that actually works in this town.
Written by Luis Serrano, Owner at Meadowsweet Heating & Air, serving Kennedale.