Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable AC Installation Across San Antonio
A new AC installation in San Antonio, FL typically runs $3,500 to $7,500 for a standard split system, and the job usually takes one full day from tear-out to cool air. That range holds steady whether you’re in a 1950s concrete-slab home near the South Side or a newer two-story in the far north. We coordinate dispatch from our Miami office and keep crews on the ground in San Antonio, so scheduling is fast and the price is written down before anything gets installed. Call (747) 966-3037 for a free estimate.
San Antonio’s heat is not a suggestion. From June through September, heat indices push past 100°F and the humidity settles in like a houseguest who won’t leave. That’s why a properly sized, properly registered, properly ducted system matters more here than in most of Florida. We’re not a call-center operation. The person who answers the phone works for Meadowsweet Heating & Air, and the crew that shows up at your door has our name on the shirt. Luis Serrano leads our team, and he’s built it around one rule: treat every San Antonio home like it’s your own.
Why Meadowsweet Heating & Air Is San Antonio’s Preferred AC Installation Company
San Antonio, FL is a Pasco County community of around 1,300 people, and word travels fast in a place this size. Our reputation here rests on the Cedarwell Care Promise – a written price before any work starts, background-checked uniformed technicians, and a 365-Day Done Right Promise that stands behind every installation. If something isn’t done right, we make it right. No runarounds, no fine print, no “that’s not covered.”
Before the crew even rings the bell, they know what’s expected. Shoe covers go on at the door. Drop cloths go down in every walk path, including the hallway where your kids play and the tile entry where the dog sleeps. When the job is finished, we send a photo of the clean-up before we leave. Not as an upsell. As the standard. That’s the difference between a company that installs an AC and a company that respects the house it goes into.
Our AC Installation team works across nine equipment brands – Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard – but we don’t sell whatever’s on the truck. We size every system to the actual house. That matters in San Antonio specifically, and I’ll explain why in a moment.
For families in San Antonio, response time is part of the trust equation. A live person answers our phones 24/7, including weekends and holidays. When your AC dies on a Saturday in August, you talk to a human, not a voicemail tree.
Heat Pump Installation in San Antonio
Heat Pump Installation in San Antonio has become one of our most requested services, and the reason goes back to one hard winter when furnace repair in San Antonio wasn’t enough to keep bills down. In January 2018, a sharp cold snap pushed lows into the upper 20s across Pasco County, and homes with strip-heat-only systems saw their electric bills triple overnight. A heat pump runs efficiently in cooling mode all summer long, then reverses to pull heat from the outdoor air on the handful of cold nights San Antonio actually gets. For most of our San Antonio customers, a heat pump installation runs $3,500 to $7,500, depending on the size and efficiency tier of the equipment.
When a Heat Pump Makes Sense
If your house currently runs on a straight-cool AC with electric heat strips, you’re paying more than you need to every winter. A heat pump cuts that heating cost by roughly half. For San Antonio’s climate – long hot summers, short mild winters, high humidity – a heat pump installation is often the right call, especially if you’re replacing an older system anyway. The incremental cost over a standard AC install is small, and the heating savings show up on the first cold snap.
What the Job Actually Involves
We don’t just swap the outdoor unit. A proper heat pump installation includes a matching indoor air handler, new refrigerant line set sized for the longer runs common in San Antonio’s ranch-style homes, and a condensate drain system that won’t clog with mineral buildup. We also set the thermostat correctly for heat pump operation – too many installers leave it in AC-only mode, and the homeowner never gets the heating benefit they paid for.
Ductless Mini Split Installation in San Antonio
Ductless Mini Split Installation in San Antonio solves a problem that central AC can’t: rooms that never get enough airflow because the ductwork was never sized right or was added as an afterthought. We see this constantly in older San Antonio homes where a garage was converted into living space, or a sunroom was built off the back without extending the main duct run. A ductless mini split installation in San Antonio typically runs $3,500 to $7,500 for a single-zone system, and that price includes the outdoor condenser, the indoor wall unit, the line set, and the electrical work.
Zones Where Central Air Falls Short
A ductless system puts a dedicated indoor unit exactly where you need it. The garage-turned-office that bakes by 2 p.m. gets its own thermostat. The in-law suite above the detached garage stops being an afterthought. Because there’s no ductwork involved, none of the efficiency is lost to a hot attic. The cool air leaves the indoor unit and goes straight into the room, which means a mini split can deliver a lower effective temperature with less energy than a central system fighting a 140°F attic.
Two-Story Homes and Bonus Rooms
Two-story homes are the classic candidate. The upstairs bedroom over the garage never cools because the single-zone builder system was never balanced for that load. Instead of replacing the whole central system, a ductless mini split can serve just that zone. Your upstairs gets comfortable, your downstairs system stops running constantly, and the electric bill drops because the central AC isn’t working overtime trying to fix a duct problem it was never designed to solve.
Trusted Brands We Service in San Antonio
We install and service Goodman, Rheem, and Daikin equipment, among six other major brands including Trane service in San Antonio, and we keep common replacement parts stocked for San Antonio customers so warranty work doesn’t stall waiting on a shipped part from Orlando. Goodman systems are popular in San Antonio’s older homes for their straightforward design and affordable parts. Rheem and Daikin are our go-to brands when a San Antonio homeowner asks for higher SEER2 ratings and better humidity control. Whatever brand you choose, every installation gets the same written-price-before-work standard, the same drop cloths, and the same 365-Day Done Right Promise. Luis Serrano does not let a brand name substitute for doing the job correctly.
Common AC Installation Problems We See in San Antonio Homes
- Builder-grade equipment sized by rule of thumb. San Antonio’s newer subdivisions were built fast, and the HVAC contractor who won the bid often sized equipment by square footage alone. No load calculation, no duct inspection. The result is an oversized single-zone system that short-cycles, never dehumidifies properly, and dies young. We see this pattern repeatedly in every new-build pocket of Pasco County.
- Builder-installed systems never registered for warranty. A Carrier, Goodman, or Rheem system installed by a builder is often never registered with the manufacturer within the required window. That turns a 10-year parts warranty into a 5-year warranty, or voids it entirely for the second owner. We check registration on every repair call, and the answer is frequently “it was never registered.”
- Ductwork in unconditioned attics cooking the air before it reaches the room. San Antonio’s attics hit 140°F to 150°F from May through September. Undersized flex duct runs through that heat lose a meaningful percentage of their cooling capacity before the air ever reaches a vent. Installing new equipment without fixing the duct runs is like buying a faster car and leaving the parking brake on.
- Oversized condensers feeding undersized evaporator coils. A mismatch between a new outdoor unit and an old indoor coil causes refrigerant charge problems, poor dehumidification, and premature compressor failure. We’ve seen this in San Antonio homes where a previous contractor “saved money” by replacing only half the system. It costs more later, every time.
Pricing for AC Installation in San Antonio, FL
Here’s the honest San Antonio pricing picture. A standard split-system AC installation in San Antonio runs $3,500 to $7,500, and that range reflects differences in home size, efficiency tier, and the condition of the existing ductwork. A heat pump installation runs the same $3,500 to $7,500. A ductless mini split installation also falls in that $3,500 to $7,500 range for a single zone. What moves the price is the SEER2 rating you choose, whether the ductwork needs replacement, and the electrical work required. We give every homeowner a written price before any work starts – that means the exact number is on paper, signed, and yours to keep before a single tool comes off the truck. A free estimate is exactly that: free, with no pressure to sign anything.
| Service | San Antonio Price Range |
|---|---|
| AC Installation (standard split system) | $3,500 - $7,500 |
| Heat Pump Installation | $3,500 - $7,500 |
| Ductless Mini Split Installation | $3,500 - $7,500 |
We Also Serve Cities Near San Antonio
From our San Antonio dispatch base, we run crews daily into AC Installation jobs across Pasco County. If you’re in Wesley Chapel, Dade City, Zephyrhills, or Brooksville, the same written-price standard and 365-Day Done Right Promise apply. Call (747) 966-3037 for a free estimate anywhere in the area.
Serving San Antonio, FL - Our Local Coverage Area
We’re based in the San Antonio area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About AC Installation in San Antonio
You likely need a full AC installation. When a builder-grade system in a San Antonio new-build never kept up from day one, the problem is almost always the sizing and the ductwork, not a single repairable component. An oversized single-zone system short-cycles, which means it cools the air but never runs long enough to pull humidity out, so the house feels warm even when the thermostat says 74°F. Repairing that system won’t fix the underlying load and airflow problem. Call (747) 966-3037 and we’ll run a Manual J load calculation on your actual house – not the square footage – and give you a written price for the fix.
Often not. Carrier and Goodman both require the original purchaser to register the system within 60 to 90 days of installation to secure the full 10-year parts warranty. If the builder never registered it – which happens more than you’d think – the warranty drops to a base 5-year parts coverage, and it may not transfer to a second owner at all. Before you close on a house, or right after, call us. We’ll pull the serial number and tell you exactly what warranty remains. That’s a free service, no strings.
Because the freezes in recent winters changed the risk calculation for a lot of San Antonio homeowners. Before 2021, a straight-cool AC with electric heat strips was the default, and the thinking was “we only need heat a few nights a year.” Then the cold snaps hit, heat strips ran at full power, and electric bills doubled or tripled in a month. A heat pump delivers the same comfort on cool nights at roughly half the operating cost of heat strips, and the incremental cost over a standard AC install is modest. Call (747) 966-3037 for a firm number on your home.
It solves the zones your ductwork doesn’t reach, and it does it without touching the ducts at all. A single-zone central system in a San Antonio home sends all its conditioned air through one set of ducts, and if those ducts are undersized or leaking or baked in a hot attic, the rooms at the end of the run never get comfortable. A ductless mini split puts its own indoor unit in the specific room that needs help – the garage conversion, the upstairs bedroom, the back office – and the cool air goes straight from the wall unit into the room, no ducts involved. It’s the most reliable fix for “this one room is always hot.”
Ask to see it. A Manual J load calculation produces a written report – a number of BTUs of cooling required, based on the orientation of your house, its insulation, its windows, its square footage, and its actual measured dimensions. If an installer gives you a price based on “square feet per ton” or “that’s what the last house took,” they’re guessing. For a San Antonio home, the rule-of-thumb approach is exactly why so many two-story homes in neighborhoods like the ones around Curley Road and Darby Road can’t hold a comfortable upstairs temperature. We show you the load calculation and explain what the numbers mean. Free estimate, with the math behind it.
Written by Luis Serrano, Owner at Meadowsweet Heating & Air, serving San Antonio and surrounding Pasco County communities with careful, clean, properly sized HVAC work.