Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Conway
Furnace repair in Conway typically costs between $150 and $700, and most calls we handle are completed the same day. If your furnace is short cycling, tripping a breaker, or blowing cold air on a January night, call (747) 966-3037 and a live person answers, no voicemail queue. We know Conway’s older concrete-block ranch homes, and we know what the lakes do to the equipment inside them. That local knowledge means we diagnose the actual problem faster, not just the symptom you noticed first.
Why Meadowsweet Heating & Air Is Conway’s Preferred Furnace Repair Company
Our Furnace Repair team works in Conway every week, on streets where the humidity off the Chain of Lakes settles into every mechanical system in the house. We carry parts for Rheem, York, Daikin, and Bryant furnaces on our trucks, which means fewer return trips and less waiting for a part to be ordered. Before any work begins, you get a written price. Not a verbal estimate. Not a range with a wink. A number on paper, and it does not change unless you approve it first.
Every technician who steps into a Conway home is background-checked, uniformed, and trained in the C.A.R.E. values: Clean up like it’s their own home, Ask before moving anything, Respect your time and quiet hours, and Explain the price before the work. Shoe covers go on at the door. Drop cloths go down before tools come out. And before the crew leaves, we send you a photo of the clean-up, so you can see the floors are exactly as they were. That’s not an add-on. It’s the Cedarwell Care Promise, and it’s part of every job since 2004. Luis Serrano leads our team, and he holds every tech to that standard on every visit.
Boiler Repair in Conway
Boiler Repair in Conway is less common than furnace work, but the homes along Lake Conway North and South that still run hydronic systems need it done right, because old cast-iron boilers and lakeside moisture are a corrosive combination. We repair circulator pumps, expansion tanks, zone valves, and aquastats, and we always check the flue for rust-through before we call a boiler safe to run. A typical boiler repair in Conway runs $250 to $700 depending on the component, and we’ll tell you the written price before we touch a wrench.
Circulator Pump and Zone Valve Work
When one room stays cold while the rest of the house heats, the problem is usually a dead circulator pump or a stuck zone valve. We test amperage draw on the pump and verify each zone valve opens and closes before quoting a replacement.
Expansion Tank and Pressure Issues
Older Conway boiler systems often have waterlogged expansion tanks, which cause pressure spikes and can crack old piping. We check tank pressure and system fill pressure, replace tanks when they’ve failed, and confirm the pressure relief valve actually lifts.
Gas Furnace Repair in Conway
Gas Furnace Repair in Conway usually comes down to one of three things: a failing ignitor, a gas valve that won’t stay open, or a heat exchanger that’s rusting faster than it should because of constant lakeside humidity. We test for carbon monoxide on every furnace call, no exceptions, because a cracked heat exchanger in a 1960s ranch with old ductwork can push CO into bedrooms before a detector ever alarms. Most gas furnace repairs in Conway land between $150 and $500 for components like ignitors, flame sensors, pressure switches, and gas valves.
Ignitor and Flame Sensor Replacement
If your furnace clicks but won’t light, or lights and shuts off after a few seconds, the ignitor or flame sensor is the likely culprit. We test both with a multimeter, clean what’s cleanable, and replace what’s not, in one trip.
Gas Valve and Burner Inspection
A gas valve that chatters, won’t hold open, or leaks at the manifold needs professional replacement. We use a combustible gas detector at every connection and around the burner assembly before and after any repair, because gas work in an older home with settled piping is not something to guess at.
Gas furnaces carry real risk. If you smell gas, leave the house and call your utility first, then call us. Never try to relight a gas furnace yourself if the smell is strong or you feel dizzy.
Trusted Brands We Service in Conway
We service Rheem, York, Daikin, and Bryant furnaces, along with Carrier, Trane, Lennox, Goodman, and American Standard. Nine brands total, and we keep common parts for the most popular models on our trucks so a Conway repair usually happens in one visit. If your furnace is older or the model is uncommon, we can source the part fast through our supplier network. You won’t be told to replace a furnace just because we don’t feel like hunting down a part. That’s not how we work.
Common Furnace Repair Problems We See in Conway Homes
- Heat exchanger corrosion from lakeside moisture. Homes within a few blocks of the Conway Chain of Lakes pull in humid air that condenses inside the furnace cabinet and accelerates rust on the heat exchanger. We inspect for cracks and rust-through on every call, because a failed heat exchanger can release carbon monoxide into the house.
- Capacitor and blower motor failure from high static pressure. Original 1950s-1970s ductwork in unconditioned attics leaks and restricts airflow, which makes the blower work harder than it should. We check static pressure on the system, not just the part that failed, so the new capacitor doesn’t burn out six months later.
- Condensate drain clogs and pan overflows. On the streets that back up to Lake Conway North, Middle, or South, drain pans overflow on systems only three to five years old. Standard 3/4-inch drain lines can’t keep up with the continuous moisture load, and the overflow shorts furnace controls and triggers secondary drain activation.
- Breaker tripping from a failing blower motor or capacitor. When an old blower motor pulls high amps, the breaker trips before the motor fully seizes. We measure amp draw and check the capacitor’s microfarad rating, then show you the numbers before we recommend a repair.
Pricing for Furnace Repair in Conway, FL
Furnace repair in Conway runs $150 to $700 for most jobs. A flame sensor or ignitor replacement is on the lower end, $150 to $300. A blower motor or gas valve replacement typically runs $350 to $700. Below is what we see across the area, written out so you can plan before calling.
| Service | Typical Price Range in Conway |
|---|---|
| Furnace Repair | $150-$700 |
| AC Repair | $150-$650 |
| Tune-Up | $80-$200 |
Every quote is a written fixed price before work starts. We offer free estimates on repair work, and calling (747) 966-3037 costs you nothing but a few minutes. We’re honest about when a repair makes sense and when a replacement is the better long-term call.
We Also Serve Cities Near Conway
While this page focuses on Furnace Repair in Conway, our crews also cover Jacksonville, Miami, Tampa, and Orlando. If you’re just outside Conway or have a rental property in a neighboring city, call us at (747) 966-3037 and we’ll confirm coverage and scheduling.
Serving Conway, FL - Our Local Coverage Area
We’re based in the Conway area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Conway
In Conway’s lakeside homes, breaker trips are usually caused by a failing blower motor pulling high amps or a capacitor that’s drifted out of spec, made worse by leaky original ductwork that forces the blower to work harder. We test amp draw, capacitor microfarads, and static pressure in one visit, then give you a written price to fix the actual cause, not just reset the breaker. Call (747) 966-3037 for a diagnostic.
You can, but on Conway’s 1950s through 1970s concrete-block ranches, a like-for-like swap often disappoints, because the old furnace was probably oversized from the start and the original ductwork leaks badly. We run a load calculation and static pressure check before recommending equipment, so the new furnace actually heats every room evenly. The extra hour of testing is free on a replacement quote.
The Conway Chain of Lakes creates a persistent humidity micro-climate that accelerates heat exchanger rust, clogs condensate drain lines, and shortens the life of drain pans and condensate pumps, even on furnaces only a few years old. Streets that back up to Lake Conway North, Middle, or South see pan overflows and secondary drain activation far more often than drier inland Orange County neighborhoods. We clean drain lines and inspect for corrosion on every furnace visit in Conway.
We repair Rheem, York, Daikin, and Bryant furnaces, plus Carrier, Trane, Lennox, Goodman, and American Standard, nine brands total. Most common parts for these brands are on our trucks when we arrive in Conway, which means one-trip repairs in the majority of cases. If your exact part is not on the truck, we’ll tell you the timeline before any work begins.
Yes, especially for 1950s-1970s Conway ranch homes where humidity and old ductwork put extra strain on every component. A tune-up runs $80 to $200 and includes a heat exchanger inspection, burner cleaning, drain line flush, and a written report of what we actually found. It’s the cheapest way to catch a rusting heat exchanger or failing capacitor before a January cold snap turns it into a $700 repair. Call (747) 966-3037 to schedule, and a live person answers any time, day or night.
Written by Luis Serrano, Owner at Meadowsweet Heating & Air, serving Conway with the Cedarwell Care Promise.