Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Fresno
Furnace repair in Fresno typically runs between $150 and $700, and most calls in the Tower District, Fig Garden, and the northwest corridor can be scheduled same-day or next morning. Meadowsweet Heating & Air has a live person answering the phone 24/7, so when your heat cuts out on a cold February morning with tule fog outside, you’ll reach a real dispatcher, not a voicemail queue. Call (747) 966-3037 and we’ll have a background-checked technician headed your way, with a written price in hand before any work starts.
Fresno’s older homes weren’t built for modern forced-air furnaces. That’s the simple truth behind a lot of what we see. The 1920s stucco bungalows near Tower District and the 1940s ranch houses in central Fresno were often plumbed for evaporative coolers only. So when a furnace “repair” becomes a first-time forced-air install, there’s deeper work involved: electrical panel upgrades, new duct runs, return-air paths, and SJVAPCD low-NOx compliance. Our Furnace Repair team understands these older houses because we’ve worked in them, not just driven past them.
Why Meadowsweet Heating & Air Is Fresno’s Preferred Furnace Repair Company
We’re part of the Cedarwell family of HVAC companies, founded in 2004, and that comes with a Care Promise that means something concrete: a written price before any work starts, shoe covers and drop cloths on every visit, a photo of the clean-up before the crew leaves, and a 365-Day Done Right Promise backing every job. If it’s not done right, we make it right. No runarounds, no fine print.
Luis Serrano leads our team, and he’s built a reputation around showing up on time, speaking plainly about what a furnace actually needs, and leaving the house the way we found it. Families in Fresno know that a furnace problem in a house with kids and pets is a disruption, not just an inconvenience. Our technicians follow the C.A.R.E. values code: Clean up like it’s their own home, Ask before moving anything, Respect the family’s time and quiet hours, and Explain the price before the work. That’s why homeowners keep calling us back when the next cold snap hits.
Boiler Repair in Fresno
Boiler Repair in Fresno usually falls into the $150-$700 range, depending on whether we’re replacing a circulator pump, a zone valve, or an expansion tank. Boilers are less common here than in the Northeast, but we do see them in older central Fresno homes, particularly in Tower District bungalows and mid-century ranches that never converted to forced air. These systems run on gas or oil, heat water, and push it through radiators or baseboards. When they fail, they tend to fail in January, right when the tule fog has been hanging over the valley for a week straight.
Circulator Pump and Zone Valve Replacement
A failed circulator pump means no hot water moving through the house, even though the boiler itself fires fine. On most Fresno homes, swapping a circulator pump or a stuck zone valve is a same-day job. We carry common Trane and Lennox boiler parts on our trucks so we’re not making a homeowner wait for a shipment from Dallas.
Expansion Tank and Pressure Issues
Boilers in older Fresno houses often have original expansion tanks that have waterlogged over 40 or 50 years of service. When the tank fails, pressure spikes and the relief valve starts dripping. Left alone, that leads to a flooded utility room and a shut-down boiler on the coldest night of the year. We test the tank, the pressure relief valve, and the fill valve on every boiler service call.
Gas Furnace Repair in Fresno
Gas Furnace Repair in Fresno is what we handle most often, and the work involves diagnosing ignition problems, failed gas valves, cracked heat exchangers, blower motor failures, and control board faults. Most gas furnace repairs in Fresno run $150-$700. A straightforward ignitor replacement on a Goodman or Rheem unit sits at the lower end of that range. A cracked heat exchanger or a failed gas valve sits at the higher end, because the repair includes safety testing and combustion analysis before we call the job done.
Heat Exchanger and Combustion Safety
A cracked heat exchanger is a genuine safety issue: it can leak carbon monoxide into the return air and into rooms where your kids sleep. If we find one, we shut the furnace down and explain the situation clearly before recommending repair or replacement. We never patch a cracked heat exchanger. We quote you honestly, with the exact part cost and labor written down before we turn a wrench.
Ignitor and Gas Valve Service
When a gas furnace clicks but won’t light, it’s usually a failed hot-surface ignitor or a gas valve that isn’t opening. On the older Lennox and Trane furnaces still common in Fresno’s mid-century homes, ignitors wear out after about five to seven years. We stock replacements for those brands and can usually have heat running the same day we arrive.
Trusted Brands We Service in Fresno
Our technicians are trained to service equipment from nine major brands, and for Fresno homes we most often work on Trane, Lennox, Goodman, and Rheem furnaces. We keep common replacement parts for those brands stocked locally for Fresno customers, so we’re not waiting on a warehouse in another state. Whether your furnace is a 1990s Lennox in a Tower District bungalow or a 2010s Goodman in a Fig Garden tract home, we can diagnose it and fix it with parts built for the job, not whatever happens to be on the shelf. Fresno homeowners appreciate that we don’t push a replacement when a $200 part will do.
Common Furnace Repair Problems We See in Fresno Homes
- Undersized original ductwork: Many central Fresno homes built between the 1920s and 1950s have ducts installed for evaporative coolers, which move far less air than a modern gas furnace blower. That mismatch causes short cycling and premature heat exchanger cracks, because the furnace overheats when air can’t move through fast enough.
- Tripped breakers from outdated electrical panels: A modern furnace blower needs a dedicated 20-amp circuit. Older panels in Fresno’s central neighborhoods often can’t deliver that, so the breaker trips every cold morning and the house goes cold.
- SJPVAPD Rule 4905 compliance failures: Out-of-area contractors sometimes install standard Title 24 furnaces that don’t meet the San Joaquin Valley Air Pollution Control District’s low-NOx requirements. That means a red-tagged install and a forced changeout the homeowner never expected.
- Tule fog corrosion on outdoor components: December through February, Fresno sits in dense fog for weeks. Outdoor heat pump and condenser coils sit in near-100% humidity, which accelerates coil corrosion and causes defrost-control issues on systems not tuned for that specific pattern.
Pricing for Furnace Repair in Fresno, TX
Here’s what furnace repair actually costs in Fresno, in plain numbers. A gas furnace repair is $150-$700, depending on the part. A boiler repair is $150-$700. A furnace tune-up is $80-$200. What moves a job up or down: the cost of the part, whether it’s a safety-critical component like a heat exchanger or gas valve, and whether the house needs additional electrical or duct work to make the repair hold. We write the price down before any work starts, so you know the number before you approve the job. Free estimates - call (747) 966-3037.
| Service | Price Range |
|---|---|
| Gas Furnace Repair | $150-$700 |
| Boiler Repair | $150-$700 |
| Furnace Tune-Up | $80-$200 |
We got a call to a 1948 stucco bungalow near the Tower District where the homeowner’s 30-year-old Lennox furnace was short-cycling and tripping the breaker every morning. Our tech found a 60-amp service panel feeding a blower motor that alone drew 12 amps, plus a cracked heat exchanger leaking CO into the return. The original ductwork was sized for a swamp cooler, not an 80,000 BTU gas furnace with a 3-ton blower. We swapped in a Carrier low-NOx unit approved under SJVAPCD Rule 4905, upgraded the electrical subpanel, and rebuilt the return-air plenum. Static pressure dropped from 0.9 to 0.5, and the furnace stopped tripping the breaker on the first cold snap.
We Also Serve Cities Near Fresno
Beyond Fresno itself, our technicians regularly serve Missouri City, Manvel, Stafford, and Sugar Land. Each of those communities has its own mix of older and newer housing stock, and we bring the same Care Promise to every job: written pricing, shoe covers, clean-up photos, and the 365-Day Done Right Promise. If you’re in a neighboring city and your furnace is giving you trouble, call (747) 966-3037 and we’ll get a technician out to you.
Serving Fresno, TX - Our Local Coverage Area
We’re based in the Fresno area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Fresno
The most common cause is an aging blower motor drawing more amps than it used to, often paired with a panel in a 1920s-1950s Fresno home that was never sized for modern furnace equipment. As the blower motor wears, its amp draw climbs until it trips the breaker. The fix is usually a new blower motor, a dedicated circuit, or both. Call (747) 966-3037 and we’ll check the amp draw and panel capacity on the spot.
In most central Fresno homes from the evaporative-cooler era, no. The ducts were built for a swamp cooler’s low airflow, not a modern furnace blower, so a like-for-like swap leaves you with short cycling and noisy, inefficient airflow. We’ll measure static pressure and tell you honestly whether your existing ducts can handle a new furnace or whether they need resizing.
Rule 4905 is the San Joaquin Valley Air Pollution Control District’s regulation requiring low-NOx combustion in residential gas appliances. It affects any furnace install or replacement in Fresno, and out-of-area contractors who don’t know the rule have had jobs red-tagged. We spec only SJVAPCD-approved low-NOx furnaces for Fresno homes, so your job passes inspection the first time.
Short cycling in Fresno’s older homes is usually an airflow problem, not a thermostat problem. If the ducts can’t move enough air, the furnace overheats and shuts itself down early. We check static pressure and return-air path on every no-heat call, because fixing the symptom without fixing the airflow just sends you back to square one.
Most furnace repairs in Fresno run between $150 and $700, with tune-ups at $80-$200. The spread depends on the part: an ignitor is at the low end, a gas valve or heat exchanger at the high end. We give you a written price before any work starts, so the number you agree to is the number you pay. Free estimates - call (747) 966-3037.
Written by Luis Serrano, Owner at Meadowsweet Heating & Air, serving Fresno, TX and surrounding communities.
When your furnace goes down in Fresno, don’t guess at the problem. Call (747) 966-3037 for a free estimate from a technician who knows the older homes, the local code, and how to leave your house cleaner than we found it. A live person answers 24/7.