Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable AC Installation Across Irving
A new AC installation in Irving typically runs $3,500-$7,500 for a standard split system swap, and the job usually takes one full day when the ductwork and electrical panel are in good shape. The real question isn’t just the equipment cost. It’s whether the system gets sized and sealed correctly for a house built on Irving’s shifting gumbo clay, under a summer sun that pushes rooftops past 140°F. That’s the question we answer before any equipment order goes in.
Meadowsweet Heating & Air serves Irving as part of the Cedarwell family of HVAC companies, founded in 2004. When you call (747) 966-3037, a live person answers. Not a voicemail tree. Not a callback queue. A person who can schedule a load calculation at your house in North Irving, off Story Road, or anywhere else in the city. We show up in uniform, with shoe covers on before the first step inside. Written price comes before any work starts. Every time.
Why Meadowsweet Heating & Air Is Irving’s Preferred AC Installation Company
We didn’t start with Irving. We learned it. And Irving teaches things a generic HVAC company never picks up. The slab-on-grade ranches off MacArthur Boulevard from the 1960s. The townhomes layered into Las Colinas in the 1980s and 1990s. The older first-generation heat pumps reaching end of life in the same decade. Each part of Irving has its own failure pattern, and a crew that doesn’t know the difference will sell you equipment before they understand your house.
Luis Serrano leads our installation work, and he’s been through enough Irving attics to know what the gumbo clay below can do to the ductwork above. Our technicians are background-checked and uniformed, and they follow the C.A.R.E. values on every job: Clean up like it’s their own home, Ask before moving anything, Respect the family’s time and quiet hours, Explain the price before the work. If a measurement doesn’t make sense, we stop and check again. Every job carries the 365-Day Done Right Promise. If it’s not done right, we make it right. No runarounds, no fine print.
Ductless Mini Split Installation in Irving
Ductless mini split installation in Irving is the practical answer for older slab homes where running new duct through tight attic spaces off Shady Grove Road or along the Story Road corridor would mean cutting into ceilings and rebuilding closets. A mini split puts a quiet indoor unit on the wall of each room you want cooled, connected to an outdoor condenser by a small refrigerant line. No ductwork. No boot collars to slip. No 3-ton duct system pretending it can move 4 tons of air.
Where Mini Splits Fit Irving’s Older Homes
A 1968 ranch with original ductwork has a choice: replace and re-engineer the whole duct system, or bypass it entirely. Mini splits bypass it. That means the back bedroom that’s always 8°F hotter than the kitchen gets its own zone, its own thermostat, its own airflow. For families in Irving who don’t want their ceilings opened up, this is the cleanest path to comfort.
Cost Range for Irving Installations
A single-zone ductless mini split installation in Irving lands within that $3,500-$7,500 installation range depending on how many indoor units you need and how far the refrigerant lines have to run. A multi-zone system covering three or four rooms sits at the upper end. The written price you get before work starts includes the outdoor unit, indoor heads, line set, electrical connection, and the clean-up photo we send before the crew leaves.
AC Replacement in Irving
AC replacement in Irving is where we see the most expensive mistake homeowners make: swapping the condenser for the same size, on the same ductwork, and wondering why the back bedroom still won’t cool. Most of Irving’s 1950s-1970s slab-on-grade ranches in North Irving and off Story Road were ducted for roughly 3 tons. But today’s 103-108°F design days push those houses toward 4-5 tons. A like-for-like condenser swap can’t move enough air through the old ducts, drives up static pressure, short-cycles the compressor, and leaves the whole system working harder for worse results.
Why Load Calculation Comes First
Before we quote a replacement, we run a Manual J load calculation. Room by room. Window by window. Duct measurement by duct measurement. What we usually find in Irving’s older homes is a mismatch between what the house needs and what the ductwork can deliver. The calculation tells us whether the answer is a 4-ton system with duct sealing, a zoning addition, or a mini split configuration that stops fighting the floor plan.
The Gumbo Clay Problem
Irving sits on expansive black-clay soil that swells when wet and shrinks when dry. That seasonal movement shifts slab foundations, and in attic systems, it pulls flex duct loose at the boot collars. A slow leak forms. Efficiency tanks for years before anyone notices because the conditioned air is bleeding into the attic instead of the bedroom. Any AC replacement in Irving needs a duct inspection first. Otherwise you’re paying to cool your insulation.
Trusted Brands We Service in Irving
We install and service Trane, Lennox, Goodman, and Rheem equipment, along with five other major brands, and we stock common replacement parts locally so Irving customers aren’t waiting a week for a capacitor or a contactor. Our AC Installation team works across all of them, which means we can match the right equipment to your house without pushing a single brand. Luis Serrano and our technicians size the system to the load, not to what’s in the warehouse.
Common AC Installation Problems We See in Irving Homes
- Like-for-like swaps on original 3-ton ductwork. The condenser gets replaced with the same size, the ductwork can’t move the air, and the system short-cycles. Static pressure climbs, the compressor ages faster, and the back bedrooms stay hot all summer.
- Flex duct pulled loose at the boot collars. Seasonal gumbo-clay foundation movement below the slab shifts the structure enough to separate duct connections in the attic. Air leaks into the attic for years, and the homeowner just thinks the system is too small.
- Aging 100-amp electrical panels. Many 1960s and 1970s Irving homes still have 100-amp service. A modern condenser with an auxiliary heat strip for winter freezes can push that panel past its capacity. The panel needs an upgrade before the equipment goes in, not after the breaker trips on the first cold night.
- Oversized equipment installed without a load calculation. Bigger isn’t better. An oversized system cools the air too fast, doesn’t run long enough to dehumidify, and leaves rooms clammy and uneven. The thermostat keeps getting adjusted because the system never actually conditions the whole house.
Pricing for AC Installation in Irving, TX
| Item | Irving Price Range |
|---|---|
| Standard split system, like-for-like | $3,500-$7,500 |
| AC repair (for comparison) | $150-$650 |
| Furnace repair (for comparison) | $150-$700 |
| Tune-up (for comparison) | $80-$200 |
The quotes we write in Irving include the equipment, installation labor, refrigerant, electrical connections, drain line, thermostat, and the clean-up photo before we leave. If your house needs duct sealing, panel work, or a load calculation first, that’s a separate line item you’ll see before anything gets scheduled. Call (747) 966-3037 for a free estimate on your specific house.
We Also Serve Cities Near Irving
Meadowsweet Heating & Air serves Irving and the communities around it, including Dallas, Balch Springs, Hutchins, and Mesquite. If you’re near AC Installation in Irving but just over a city line, call us and we’ll confirm that your address is in our service area.
Serving Irving, TX - Our Local Coverage Area
We’re based in the Irving area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About AC Installation in Irving
Why does a same-size AC replacement still leave my North Irving ranch’s back bedrooms hot?
Because the ductwork was sized for a smaller cooling load decades ago, not for today’s 103°F+ summer afternoons. A like-for-like condenser swap doesn’t fix undersized ducts, and it can’t overcome the airflow restriction that leaves the farthest bedroom hot. A load calculation will show whether the answer is duct sealing, larger duct runs, a zoning system, or a mini split for that specific room. Call (747) 966-3037 and we’ll measure it before we quote anything.
Does my older Irving house need an electrical panel upgrade before a new AC goes in?
If your panel is still 100-amp service from the 1960s or 1970s, which is common in North Irving and off Story Road, the answer is often yes, especially if the new system includes a heat strip for winter freezes. A modern condenser plus an auxiliary heat strip can push a 100-amp panel past its safe capacity. We check this during the load assessment and include any panel work as a separate line item, so you see the full picture before any work starts.
How does Irving’s black-clay soil affect an AC installation?
Irving sits on expansive gumbo clay that swells with moisture and shrinks in drought. The seasonal movement shifts slab foundations gradually, and that movement can pull flex duct loose at the boot collars in attic systems. When we install a new AC in Irving, we inspect the duct connections as part of the job, because a new condenser on leaky ducts wastes its own efficiency. The soil doesn’t change your equipment choice, but it absolutely changes what we check before and during the install.
What does SEER2 mean for an AC I install in Irving?
SEER2 is the updated efficiency measurement that took effect for new equipment in 2023, and it reflects more realistic ductwork and static pressure conditions than the old SEER rating. For Irving’s hot summers, where your AC runs hard from May through September, a higher SEER2 rating means a lower electric bill for the same amount of cooling. The specific SEER2 you need depends on your house, your ductwork, and your budget. We’ll show you the efficiency numbers and the dollar trade-offs before you choose.
Do you install ductless mini splits in Irving’s older slab homes where running new duct is impractical?
Yes, and that’s often the smartest move for the 1950s-70s ranches where the attic is tight, the ductwork is original, and the floor plan has never cooled evenly. A ductless mini split installation puts a quiet unit on the wall of each room you want conditioned, with a small refrigerant line running to an outdoor condenser. No ductwork, no attic work, no cutting into ceilings. The back bedroom finally gets its own airflow and its own thermostat, and the system doesn’t fight the old duct design at all.
Key Takeaways
- AC installation in Irving runs $3,500-$7,500 for a standard split system, before any duct or panel work that older homes often need.
- Most North Irving and Story Road ranches were ducted for 3 tons but need 4-5 tons on today’s 103-108°F design days, which means a like-for-like swap often fails.
- Gumbo-clay foundation movement under Irving’s slabs pulls flex duct loose at attic boot collars, causing slow leaks that undermine any new system.
- Ductless mini splits bypass old ductwork entirely, making them a strong fit for Irving’s older slab homes where running new duct is impractical.
- Every job includes a written price before work starts, shoe covers and drop cloths inside the home, a clean-up photo before the crew leaves, and the 365-Day Done Right Promise.
Call Meadowsweet Heating & Air for AC Installation in Irving
If your Irving house needs a new AC, a replacement that won’t fight the old ductwork, or a ductless mini split for the rooms the current system can’t reach, call (747) 966-3037. A live person answers, day or night. We’ll schedule a load calculation, write a fixed price, and show up in uniform with shoe covers on. You’ll know exactly what the job costs before anything starts, and you’ll have a written guarantee that it’s done right for a full year after.
Written by Luis Serrano, Owner at Meadowsweet Heating & Air, serving Irving and the surrounding Metroplex as part of the Cedarwell family of HVAC companies.