Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable AC Installation Across Redwood
A new AC installation in Redwood typically runs $3,500-$7,500, and the right system for your home depends on load calculation, not guesswork. We work throughout Redwood every week, and our crews know the difference between a 1970s ranch home on pier-and-beam and a four-year-old tract house with builder-spec equipment. If your AC is struggling through another south-central Texas summer, call (747) 966-3037 for a free estimate. We’ll give you a written price before any work starts.
Why Meadowsweet Heating & Air Is Redwood’s Preferred AC Installation Company
Redwood homeowners call us because we treat the house like it’s ours. Shoe covers go on at the door. Drop cloths protect floors from the entry to the attic access. Before we leave, you get a photo of the clean-up, not a promise. That’s the Cedarwell Care Promise, and it’s on every job we do in Redwood.
Luis Serrano leads our team, and he holds every technician to the C.A.R.E. values code: Clean up like it’s your own home, Ask before moving anything, Respect the family’s time and quiet hours, Explain the price before the work. If a kid is napping or a dog is anxious, we work around it. We don’t rush, and we don’t leave a mess.
We answer the phone with a live person 24 hours a day. No voicemail queue, no answering service that takes a message and hopes someone calls back. When your AC quits on a 103°F afternoon in Redwood, you talk to someone who can actually help.
AC Replacement in Redwood
AC replacement in Redwood usually means pulling out a builder-grade system that was never sized for the house it was installed in, then putting in equipment matched to a real load calculation. A standard split system replacement here runs $3,500-$7,500. The job involves removing the old condenser and evaporator coil, inspecting the ductwork and return air, and installing the new system so it can actually hold setpoint in July.
When Replacement Beats Repair
If your compressor is still under warranty, a repair might make sense. But when a four-year-old system has already burned through two capacitors and the static pressure is off the chart, you’re not fixing a part problem. You’re fixing a sizing problem. We’ll show you the numbers before you spend anything.
Ductwork Evaluation Before Equipment Swap
A lot of Redwood replacements fail because the new unit goes in on top of the same undersized ducts. We measure static pressure and airflow before we quote. If the ducts need work, you’ll know that upfront, not after another summer of hot rooms.
Central Air Conditioning Installation in Redwood
Central air conditioning installation in Redwood starts with a Manual J load calculation so the tonnage matches the home’s actual heat gain, not a rule of thumb from the subdivision builder. A new central air install with a proper load calculation runs $3,500-$7,500 depending on tonnage, efficiency, and duct condition.
Load Calculation First
We don’t sell you a 3-ton unit because the old one was 3 tons. We measure windows, insulation, roof exposure, and the home’s orientation. In Redwood’s newer tracts, that often means the old system was undersized by half a ton or more. That’s the difference between holding 75°F and running nonstop from noon to midnight.
SEER2 and Long-Term Comfort
Higher SEER2 ratings lower your summer electric bills, but only if the airflow is right. We’ll help you pick an efficiency that makes sense for your budget and your ductwork. No upsell, just the numbers.
Trusted Brands We Service in Redwood
We install and service Rheem, York, Daikin, and Bryant equipment, among others, so you’re not locked into whatever brand the builder picked. If you need parts, we keep common capacitors, contactors, and thermostats stocked for fast turnaround in Redwood. That means less waiting when the heat hits and your condenser won’t start.
Common AC Installation Problems We See in Redwood Homes
- Builder-grade tonnage mismatches. Newer Redwood subdivisions often have heat pumps sized by square footage alone. The system short-cycles or never satisfies setpoint once the Gulf moisture pushes the heat index past 105°F.
- Post-Uri heat pump retrofits on old ducts. After the 2021 freeze, a lot of homes got new heat pumps strapped to ductwork sized for 1985. The equipment looks new, but the static pressure is quietly killing blower motors and evaporator coils.
- Warranty registration gaps. Builder-installed equipment is frequently registered to the builder or not registered at all. Homeowners find out at the first refrigerant leak that parts and labor coverage never followed the house.
- Undersized return air. We regularly find single 14-inch returns serving entire floors in newer Redwood homes. That restriction drives up compressor temperatures and shortens system life by years.
Pricing for AC Installation in Redwood, TX
Here’s what Redwood families can expect to pay for a new AC system in today’s market:
| Service | Typical Price Range |
|---|---|
| AC Installation (standard split system, builder-grade replacement) | $3,500-$7,500 |
| AC Replacement (heat pump swap with duct evaluation) | $3,500-$7,500 |
| Central Air Conditioning Installation (new install with load calculation) | $3,500-$7,500 |
A basic tune-up in Redwood runs $80-$200. AC repair work ranges $150-$650, and furnace repair $150-$700. What changes an installation quote most is ductwork condition, required tonnage, SEER2 rating, and whether the return air needs upsizing. You’ll get a written price before any work starts. Call (747) 966-3037 for a free estimate.
We Also Serve Cities Near Redwood
Our crews cover Redwood and the surrounding corridor, including AC Installation in Redwood and nearby areas like Houston, San Antonio, Dallas, and Fort Worth. If you’re just outside Redwood proper, call us anyway. We’ll let you know the soonest we can be there.
Serving Redwood, TX - Our Local Coverage Area
We’re based in the Redwood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About AC Installation in Redwood
A four-year-old Redwood home can absolutely need a full replacement if the builder installed undersized equipment and the ductwork was never right. We see compressors burned through capacitors and coils frozen because the system has been fighting low airflow since day one. When the tonnage is wrong, no repair fixes the underlying problem. Call (747) 966-3037 for an honest diagnosis.
Often not. Builder-installed equipment is frequently registered to the builder’s name or never registered at all, which means the manufacturer’s parts warranty doesn’t follow the house. We can check your serial number and registration status during an estimate. If coverage lapsed, we’ll show you exactly what a new installation includes and what it costs.
Hot rooms in newer Redwood homes almost always come back to airflow: undersized ducts, a single undersized return, or a system that was never load-calculated for the actual heat gain. The AC runs continuously because it can’t move enough air. We measure static pressure and room-by-room airflow to find the restriction, then quote the fix. Call (747) 966-3037 to schedule.
Heat pumps work well in Redwood, but the 2021 freeze exposed a real risk: undersized ductwork and missing heat strip capacity. If you’re switching from a furnace to a heat pump, we size the heat strips for a hard freeze and evaluate the ducts at the same time. A proper heat pump installation runs the same $3,500-$7,500 range. It’s worth doing right once.
For Redwood’s long cooling season and high dewpoints, a SEER2 rating in the 15-17 range usually balances upfront cost with summer electric bills. Going higher than that only pays off if the ductwork is already efficient. We’ll show you the payback math based on your actual usage, not a national average. Call (747) 966-3037 for a free estimate.
Redwood’s Newer Homes Need More Than a Box Swap
Redwood sits in a rapidly expanding Guadalupe County corridor where rural ranch-era properties and hastily built new-subdivision homes exist side by side. That means our technicians have to bridge two completely different equipment generations on back-to-back calls. The area’s growth as a San Antonio exurb has flooded it with builder-grade systems that were undersized for actual south-central Texas heat loads, a mismatch locals pay for every July and August in emergency service calls.
On a new-build stretch off the Redwood Road corridor, we replaced a builder-grade 3-ton heat pump in a four-year-old home where the original duct system was still necked down to a single 14-inch return. The equipment looked new, but the static pressure was off the chart and the compressor had already burned through two capacitors. We ran a proper load calculation, upsized the return and trunk, and set the new condenser coil and evaporator coil to match the actual tonnage the house needed for a south-central Texas August. The homeowner’s first summer on the new system held setpoint without the emergency calls that had defined the previous three.
This page exists because Redwood’s HVAC problems are specific. Builder-grade tonnage mistakes, 2021 post-Uri ductwork leftovers, and warranty registration traps define what we fix here. If your AC Installation was done by the builder and your home never cools right, the problem probably started before you moved in. We can show you exactly what’s wrong and what it costs to make it right.
Written by Luis Serrano, Owner at Meadowsweet Heating & Air, serving Redwood since the company’s founding in 2004.